A rendering of a crawlspace with one concrete block pier wrapped in white vapor barrier, a wide insulated duct passing close by, and the floor and lower walls sheeted in white reinforced barrier receding toward the far wall

Summit Home ServicesCrawlspace vapor barriers · Wake County, NC

Better starts
beneath.

Free crawlspace inspection

About an hour

Your address stays on this page until you choose to send it.

Or Call (919) 928-2847Text us

Raleigh-Durham, now

88%

outdoor humidity, 70°F

Above 70 percent, crawlspace air supports mold growth.1

Illustration

We seal crawlspaces in Wake County against ground moisture, the musty air that rises into your house, and the conditions mold grows in.

Who we are

Sound familiar?

Most crawlspace problems start the same way.

Moisture from the soil evaporates into the open space under your house.2

  • A musty smell indoors, worst on humid days

  • Mold or dark staining on the floor joists

  • Floors that feel soft or cold

  • Water or wet soil under the house after rain

  • Insulation sagging or lying on the ground

  • A crawlspace moisture note on a home inspection report

  • Buying or selling?

    If an inspection flagged moisture in the crawlspace, text us a photo of that page. Texts are answered right away.

    Text us the page

What we install

Two levels of protection, depending on what your crawlspace needs.

Fig. 1 Section, foundation wall to pier

Screws and washers over butyl tape12 to 18 in5 in below the joists12 mil reinforced polyethyleneHeavy-duty reinforced linerSeams lapped 12 in, sealedPier wrappedVent openVent coveredFloor joistsSoil
  • Partial encapsulation

    The floor lined, the walls covered 12 to 18 inches up and fastened.

    • The whole floor lined, seams lapped and sealed
    • Walls covered 12 to 18 inches up, mechanically fastened
    • Every pier wrapped and every penetration collared
    • Before-and-after photographs
  • Full encapsulation

    Walls and piers lined to 5 inches below the joists, vents covered where needed.

    • The whole floor lined, seams lapped and sealed
    • Walls lined to 5 inches below the floor joists
    • Piers wrapped to the same height
    • Vents covered where full encapsulation needs it
    • Before-and-after photographs

The details

The details that keep a vapor barrier sealed.

A vapor barrier only works if every edge is sealed. These are the edges, and how we seal them.

  • Fig. 2.1 Walls

    Block wallButyl tape, double-sidedLinerWasherMasonry screw

    We fasten the top edge of the wall liner with masonry screws through washers, over double-sided butyl tape.

  • Fig. 2.2 Seams

    12 in lapUpslopeSealed with mastic and meshLower sheet first

    Laps of at least 12 inches, sealed, and run upslope so water crosses a seam rather than entering it.

  • Fig. 2.3 Piers

    4 in up12 in outPierFloor sheet laps the flap

    Each pier gets its own wrap, at least 4 inches up and 12 inches out, so the floor sheet laps over a flap.

  • Fig. 2.4 Pipes and posts

    Patch cut with an XFlaps turned upTaped as a collarPipe

    Every pipe, duct and wire through the sheet gets a patch cut with an X, slid over it and taped as a collar.

  • Fig. 2.5 Insulation

    Insulation rehungFloor joists

    We rehang loose insulation as part of the job.

See the installation standard

Before and after

Wet ground and open air, then one sealed surface.

Fig. 3 Before and after

Drag, or use the arrow keys

The process

Five steps, one price, and a timeline you know before we start.

  1. 01

    Check your address

    Type it above. You know at once whether we cover your town.

    Seconds

  2. 02

    Free inspection

    We go under the house, measure, and check the moisture, the framing and the insulation.

    About an hour

  3. 03

    Your fixed price

    One figure for the scope we measured. It holds unless you change the scope.

    After the inspection

  4. 04

    Install

    The liner goes down, sealed at every edge, and loose insulation is rehung.

    Depends on the job

  5. 05

    Before and after photos

    Photographs of your crawlspace, seams and edges included, so you can check the work.

Texts are answered right away. See every step

Service area

Nine towns in Wake County.

Type your address in the card at the top and the map marks your town.

RaleighCaryApexMorrisvilleHolly SpringsFuquay-VarinaGarnerWake ForestKnightdale
Wake County, NC

Questions

Before you call.

Is the inspection really free?

Yes. We come out, go under the house, measure and check the moisture. It costs you nothing.

How long does the inspection take?

About an hour.

Will the price change once you start?

No. You get one fixed figure for the scope we measured, and it holds unless you change the scope.

How long does an install take?

It depends on the job: the size of the crawlspace, what is in it, and the system. You know the timeline with your fixed price, before we start.

Which system do I need, partial or full?

That is decided at the inspection, from what we measure and find under your house.

What happens to the old insulation?

Loose insulation hanging from the joists is rehung as part of the job, and priced after the inspection.

What if there is standing water?

Standing water has to be dealt with before a liner goes down. We tell you what we find at the inspection.

How quickly do you answer?

Texts are answered right away.

Free inspection

Book your free inspection.

About an hour under the house, then one fixed price. Texts are answered right away.

Your address stays on this page until you choose to send it.